[Crown_Enthusiast2023]

I used a small flat head screw driver.. wrap it around with the fiber tower to prevent damages then kind of slide that into the slot between toyota emblem and fry it open a little.

You can see that the double tape start to peel off a little and create a small gap.. Use the second small flat head with fiber tower and put it in the gap.

There is a chance that whole black assembly comes off.. don't worry that will make your job easier .. you can remove the emblem and snap it back on....
I bought the old classic crown logo and it's bigger than the slot. I had to use the dremmel tool to make it smaller so it can fit..
If i do it again, i will go with the emblem below:

It fits perfectly in the slot without modification. You can buy this on ebay for around $45.
Hope that helps.

 

[michaelkingofsmog]

It was fairly easy. I used fishing line to cut the double adhesive tape then use an old fiber towel and gasoline to remove the residue remain.
You can just wet the towel with a little gasoline and wipe. The remainder of the tape will come right off.
Good luck and share with us the final result.

thank you

 

[grnblur]

I love it! Toyota should make that available to NA customers. I think it would help give the Crown a unique image with the general public and may help improve its popularity.

Elmhurst Toyota is selling these
75314-30060

Genuine Toyota Crown Front Bumper/Grill Emblem 75314-30060 | Elmhurst Toyota Parts

Genuine Toyota Crown Front Bumper/Grill Emblem 75314-30060

parts.elmhursttoyota.com

 

[henryqiu]

are you able to show us where you had to Dremel to make it fit? Because aren’t they the same oval size and shape?

 

[Manny]

Ordered from zenmarket.jp
Well worth it

Item page

Where to buy Japanese products and ship them to your country? The best proxy shopping service - ZenMarket makes it easy! Shop directly from Mercari, Amazon Japan, Rakuten, and Rakuma, or bid live on JDirectItems Auction. Your one-stop for—secure, simple, and hassle-free shopping!

zenmarket.jp

 

[doughboy74]

Purchased straight from Toyota…

autoparts.toyota.com/products/product/emblem-fr-bumper-7531430060

looks good.

 

[Crowned]

Purchased straight from Toyota…

autoparts.toyota.com/products/product/emblem-fr-bumper-7531430060

looks good.
View attachment 713

It does look really good @doughboy74! Congrats and welcome to the forum! Was the emblem easy to install? How long have you had your Crown?

 

[doughboy74]

It does look really good @doughboy74! Congrats and welcome to the forum! Was the emblem easy to install? How long have you had your Crown?

I’ve had mine since April 2023 when they first started getting them in stock. Removing the old Toyota emblem was very easy with a hair dryer and floss. Then just clean up and residue. Prepped the area and installed the Crown emblem. I bought two as my ride is wrapped in 3M so if/when I swap it out, I have another ready.

 

[Larry Johnson]

I have a white rear crown emblem like the one above but would really like a black oval crown emblem for my back hood..... any idea where I can purchase one (johlarry@gmail.com)

 

[Crown_Enthusiast2023]

For the rear, I use a small flat head screwdriver but wrap the tip with 3m tape so it doesn’t scratch the car. This will either remove the logo or whole assembly. Don’t worry if you remove the assembly, press it back on with a little pressure and it will snap right on.